Page 91
724-746-5500 | blackbox.com
Chapter 4: Configuration
Select “Configuration > Save” in the main menu.
By selecting this menu item, the active configuration of the matrix is saved to the
permanent matrix memory. By default, the last configuration that has been saved
in this way will be restored after the matrix restarts.
NOTE: Changing or saving configurations blocks the matrix memory and freezes
all OSD menus for a few seconds. The switching connections are not
affected by this freeze.
If you select “Auto Save” within the system settings, it will automatically save the
configuration periodically.
4.9.2 Saving Configurations (Internal)
In this menu, the current matrix configuration to predefined storage locations is
saved. However, it does not replace configuration buffering.
You can access the menu via OSD or Java:
Figure 4-45. OSD and Java icons.
In Active, the name and detailed information of the current configuration are
shown. This configuration can be saved now.
In Default and File #1 to File #8, the name and the detailed information of the
respective saved configuration are shown. You can overwrite these storage
locations.
The storage location to be overwritten by the current configuration must be
selected explicitly.
Afterwards, the current configuration will be saved to this storage location and
will be immediately shown in the menu. The previously saved configuration that
was saved to this storage location is deleted.
OSD
You can save the created configuration within eight storage locations in the matrix
(File #1–File #8). You can also save a configuration as the default configuration.
1. Select “Configuration > Save As…” in the main menu.
2. Select the required storage location “(File #1–File #8)” or “Default.”
