A SERVICE OF

logo

Open as PDF
next previous
724-746-5500 | blackbox.com
Page 21
ACXMODH User Manual
Chapter 3: Installation and Operation
Figure 3-8. Example of a 4-Port chassis that shows three power connections.
You can connect the power connections from the chassis to the cards that require power (any card that has a brown power
connection). If you run out of power jumpers from the main power supply, use the Power Jumper Cable to connect the cards
from existing cards using the secondary power connection (see image below).
Figure 3-9. Example of jumping power from one card to another.
Most Interface Cards will have two power connections (see right card in the image above). It doesn’t matter which connector is in
or out, they both can act as an input or output. Use a power jumper to link these cards together so both cards can get power.