A SERVICE OF

logo

Page 47
724-746-5500 | blackbox.com
Chapter 4: Configuration
You can enter the OSD of the ServSwitch DKM FX:
• via keyboard connected to the CPU board
• via keyboard connected to a CON unit of an extender
Entering OSD
1. Start Command Mode with the hotkey (see Section 5.1).
2. Press <o> to open OSD. You will see a list of all available CPUs as a start menu.
3. Press <Esc> to enter the main menu.
Leaving OSD
Press <Shift> + <Esc> simultaneously. The OSD will close without any further
changes and the currently active CPU connection will display.
Menu Structure
Figure 4-2. Menu structure.
The general layout of the OSD is structured into three areas:
• Upper status area (top-most two text lines)
• Working area