A SERVICE OF

logo

724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 15
Chapter 3: Installing the Heat-Transfer Door
8. Screw the valve caps onto the air-purging valves and hand-tighten them to provide a secondary seal.
3.3.4 Completing the Installation
Complete the following steps:
1. Install the raised floor tile (on a raised floor) that was removed or route the hoses away from the IT enclosure (on a non-raised
floor).
2. Close and latch the Heat-Transfer Door.
NOTE: If the IT Enclosure is on a non-raised floor, you might have to manually keep the hoses parallel and move them back into
position as you close the door.
Figure 3-9. Straight-angle hose kit.
Figure 3-10. External right-angle hose kit (left) and Internal right-angle hose kit (right).