SERVSWITCH™ MULTI
36
Figure 3-4. A Dual-Monitor ServSwitch Multi system.
Once you have all of the components of your entire ServSwitch Multi system installed, you will need to use the
UICD to enable the dual-monitor setup. Here’s how to do so:
1. If you haven’t yet added the dual-monitor computer to the Switch’s on-screen configuration records,
follow the instructions for doing so in Section 9.3.1.A.
If you have previously entered the computer into the on-screen configuration, follow the instructions
for editing that computer’s record in Section 9.3.1.B.
In either case, when you reach the “Dual Video” feature, press the space bar to enable it.
2. Enter the Administrator-Controls Menu (see Section 9.4) and select the “System Configuration” option.
Page down and highlight the “Dual Monitor Support Card Address” field (see Section 9.4.3.H). Enter the
address of the UUIC that the secondary monitor is attached to. Until you enter a value in this field, dual-
monitor support is still disabled regardless of what you did in step 1.
Sun computer with
dual video output
User station with
primary monitor
Secondary
monitor
ServSwitch Multi with two
CPU-Interface Cards, a
UICD, and a UUIC installed
