CHAPTER 4: BASIC OPERATIONS
31
c. Press the right mouse button to close the Set Position window.
Figure 4-10. Set Position window
4. 4. Click OK to save the changes, or click X or press Escape to exit without saving the
changes.
Setting the keyboard country code
By default, the appliance sends the US keyboard country code to USB cables attached to
target devices and the code is applied to the target devices when they are turned on or
rebooted. Codes are then stored in the SAM. Using a keyboard code that supports a
language different from that of the appliance firmware will cause incorrect keyboard
mapping.
If multiple keyboards are connected to the local port, they must be of the same type (PC or
Mac) and of the same language. Only local users can view or change keyboard country
code settings.
Issues might arise when you use the US keyboard country code with a keyboard of another
country. For example, the Z key on a US keyboard is in the same location as the Y key on
a German keyboard.
You can use the Keyboard window to send a different keyboard country code than the
default US setting.
Figure 4-11. Keyboard window
To change the keyboard country code, complete the following steps:
1. Press Print Screen to start the OSD interface. The Main window opens.
2. Click Setup > Keyboard. The Keyboard window opens.
3. Select the country code for the keyboard, and click OK. Confirm the change in the
Keyboard Warning window.
