A SERVICE OF

logo

13
CHAPTER 5: Installation
5.2 Hardware Installation
The ISA Card can be installed in any of the PC expansion slots. The Card contains
several jumper straps for each port that you must set for proper operation.
1. Turn off PC power. Disconnect the power cord.
2. Remove the PC case cover.
3. Locate an available slot and remove the blank metal slot cover.
4. Gently insert the Card into the slot. Make sure that the Card is seated
properly.
5. Replace the screw.
6. Replace the cover.
7. Connect the power cord.
Installation is complete.
Self-Test
To perform a self-test on the card, connect the transmit and receive data pins
together. If running 422/485, make sure the plus leads are not connected to
the minus leads. Execute the SLT program provided on the supplied utility
diskette.