welcome contents
installation
operation
rter
inormation
8
Connections at the remote module
1 Place the remote module adjacent to the user location.
3 Attach the leads of up to four
USB devices (two of which are
usually a keyboard and mouse)
to the sockets located adjacent
to the video output connector.
To video
monitor
4 [Dual VGA variant only] Optionally
attach a serial device lead to the
male serial connector on the
remote module.
2 Attach the lead from the video
monitor to the video out socket
on the remote module.
[Dual VGA variant only]
Optionally attach the lead from
a second video monitor to the
upper video out socket on the
remote module.
To secondary
video monitor
To USB devices,
e.g. keyboard,
mouse, etc.
To RS232
serial device
See the Important note on page 5
[MS2 variant only] Note: When connecting four USB devices to the unit,
ensure that their total power requirements do not exceed 1700mA (1.7A).
The USB standard states a maximum allowable current draw of 500mA
(0.5A) per device, although most devices remain well below this limit - USB
keyboards and mice typically require 100mA. Each X50 contains a self-
resetting fuse that will prevent damage by shutting down the unit if the
total power draw becomes excessive.
