15
CHAPTER 3: Installation
3. Installation
3.1 Rackmounting (Optional)
If you want to mount the ServSwitch Jr. MP in a 19", 23", or 24" rack, you will need
a ServSwitch Rackmounting Kit (our product code RMK19M, RMK23M, or
RMK24M respectively). The Switch is pre-drilled to accept the Kit’s rackmounting
screws. See Appendix C for more information.
3.2 Connecting the Monitor, Keyboard, and Mouse
CAUTION!
Make sure that the monitor, keyboard, and mouse you plan to use can
meet the demands of your application—see Section 4.1. Also, note that
the ServSwitch Jr. MP does not support most dongles.
1. After you verify that the ServSwitch Jr. MP is powered OFF, plug the HD15
male connector of the video cable from your monitor into the HD15 female
port on the ServSwitch Jr. MP’s rear panel that’s labeled with the monitor
icon ( ).
2. Plug the 6-pin mini-DIN male connector of your PS/2 type keyboard’s cable
into the 6-pin mini-DIN female port on the ServSwitch Jr. MP’s rear panel
that’s labeled with the keyboard icon ( ).
3. Plug the 6-pin mini-DIN male connector of your regular PS/2 or PS/2 wheel
type mouse’s cable into the 6-pin mini-DIN female port on the ServSwitch Jr.
MP’s rear panel that’s labeled with the mouse icon ( ).
