30
DUAL-PORT NETWORK POWER SWITCH
When the user mode is active, the /S command will produce the screen shown in
Figure 5-2. It lists the status and parameters only for the plug(s) owned by the user
password entered at login. If a separate user password has been assigned to the
other plug, the User Mode Status screen will not list the status for that plug. In user
mode, plug passwords cannot be displayed.
Figure 5-2. User Status screen.
5.3 Boot/On/Off Commands
These commands are used to boot or toggle the on/off status of the Dual-Port
Network Power Switch’s two switched plugs. If the same password has been applied
to both switched plugs, commands can be directed to plug 1, plug 2, or both
switched plugs. If a separate user password has been assigned to each plug, then
commands can only be applied to the plug that is owned by the user password that
was entered at login. Plugs may be specified by name or number.
NOTES
When user mode is active, commands will only be applied to plugs
owned by the user’s password. Commands will not affect a plug owned
by another user password.
When system mode is active, commands can be applied to both
switched plugs.
Wait for the “TPS>” prompt to appear before entering commands. The
prompt will not reappear until the previous command is complete.
Commands are not case sensitive. All commands are invoked by
pressing [Enter].
Dual-Port Network Power Switch v1.00 Site: BLACK BOX CORPORATION
Plug Name Status Boot Delay Password Default
2 ROUTER_B OFF 15 Sec (defined) ON
Modem Init. String: ATE0M0Q1&C1&D2S0=1
Modem Disc. String: +++ATZ
Communication Settings: 9600,N,8,1
Command Echo: OFF
Disconnect Timeout: 30 Min
Command Confirmation: ON
Automated Mode: OFF
Button Mode: ON
“/H” for Help
