4 Description
The basic housing has a 10/100/1000TX Ethernet connection and two USB
ports (USB 1 and USB 2) for KVM applications.
The console port is exclusively for maintenance work and is not user-
accessible.
The reset button on the left returns the device to factory default setting if
required. Press this button for at least five seconds until the green power
LED starts flashing to signal a reboot.
The DVI module has two connections: Video In and Video Out. The
VX-HDV-IP can be configured as an encoder or as a decoder. Only one
connection can be activated at a time.
Æ The quality of the video cable can influence the video image quality.
The LED of the configured port stays red if no connection is detected. This
indicates whether it is configured as an encoder or a decoder, because the
LED only goes green if the VX-HDV-IP detects a recognizable connection.
The port is then ready for use.
Front view of VX-HDV-IP with DVI module
The VX-HDV-IP has two 12 VDC power inputs; one is redundant. Both power
inputs are monitored by a switch contact that closes to signal a power failure,
for example, to a control system.
Rear view of VX-HDV-IP
