22 en | Installing the DINION capture DINION capture 5000/7000
| 1.0 | 2012.01 Installation Manual Bosch Security Systems, Inc.
NOTICE!
For purposes of evaluation and testing of the mounting
bracket's integrity under static loading at CSA, the unit was
mounted to a drywall surface as per the procedures below:
– Locate a stud in the wall and mark the outside edges of the
stud.
– Using the wall mount bracket as a template, align the
mounting hole with the center of the stud.
– Mark the point on the wall in the center of the hole where
the mounting bolt will be positioned.
– Remove the wall mount bracket and drill a pilot hole at the
marked point.
– Align the wall mount bracket mounting hole with the hole
drilled in the wall.
– Using a screwdriver, secure the wall mount bracket by
screwing a 2.5 in. screw with washer securely into the
stud.
– Follow this procedure to attach the three remaining
screws.
NOTICE!
The camera has not been evaluated for safety requirements
using other mounting kits.
