Indoor Pendant & In-ceiling Models | User Manual | On-Screen Programming
Bosch Security Systems | 10 December 2003
EN
|
UM3
1ON-SCREEN
PROGRAMMING
The BasicDome software offers user-friendly on-screen
programming. A few common commands are shown
below. At the end of this section is a complete list of
user commands for your reference.
1.1Saving a scene (Preset)
The BasicDome allows up to 99 scenes to be saved and
recalled instantly. A saved scene is called a Preset. When
a Preset is saved, the position, zoom, and most camera
settings are stored.
SET-100-ENTER displays the Preset menu (see
FIGURE 1).
Figure 1: Naming a Scene (Preset)
Menu options are store, delete, name, or edit. Up to 99
scenes can be saved, and the system automatically
selects the next available number. When a Preset is
saved, it can be named via the joystick, FOCUS, and
IRIS (see FIGURE 2). The name can be up to 16
characters long. This Preset can later be viewed using
the SHOT-#-ENTER command, where
# is 1-99.
Figure 2: Naming a Screen (Preset)
1.2 Preset Tour
Once Presets are stored, the BasicDome can cycle
through all Presets or selected Presets. This is called a
Preset tour. To include or remove presets on a tour, type
SET-900-ENTER. This displays the current presets and
indicates if they are on the tour. Follow the on-screen
instructions to include/remove Presets from the tour
(Note: Presets removed from the tour can still be accessed
manually). Type ON-8-ENTER to activate the preset tour.
To c hange the time duration between presets, type
ON-15-ENTER and follow the on-screen instructions.
Figure 3: Preset Tour Menu
