Bosch Security Systems
Divar | Installation Manual | Menu system EN | 5-13
>>> COM port
• The COM port is an RS232 serial port used mainly for connecting
a PC or an alarm panel to the unit.
• Most parameters are fixed. Select the appropriate baud rate.
>>> ATM/POS setup (requires bridge and license)
• The list of all ATM/POS bridges connected to the unit shows the IP
address and the connection status.
• Use the arrow keys to move to a bridge and select it to open a
terminal configuration menu for that bridge.
Terminal Setup
• Edit the IP address of the selected bridge if required.
• The names of all terminals connected to the bridge are shown with
their associated camera. Only data from terminals with an assigned
camera is stored.
• Use the arrow keys to move to a terminal and select it to open a list
of available cameras. Select a camera to assign it to the terminal. A
camera cannot be assigned to two terminals. A terminal can only
have a single camera assigned to it.
• Press F1 to remove all camera assignments.
>> LICENSES
• Fill-in the key of any additional licenses you purchase exactly as supplied.
• The MAC address and a description of the installed licenses are shown at
the bottom of the menu-screen.
>> INPUT AND OUTPUT CONTACTS
• The contacts of the input and output relays default to normally
•open (N/O).
• Place a check mark in the box under a specific relay to set its contacts to
normally closed (N/C).
• Press a camera key to place or remove a check mark.
PROFILES >
Six different profiles can be stored. These profiles can be activated by an input
switch or by a date or time. The profiles contain configuration settings for
recording data, handling events and restricting access. You can define a calendar
that automatically selects profiles. These profiles can be configured for day,
night, weekend or holidays for example.
>> CALENDAR SETUP
• The use of profiles is defined in a calendar that covers one week. This
calendar is then repeated for subsequent weeks.
• A profile is specified at intervals of 15 minutes for each day of the week.
• You can program exception days to change profiles for special days and
holidays.
>>> Calendar edit
•The Calendar Edit menu shows the profile identification numbers
used in a 24-hour period (0 to 23). Each hour is divided into four
15-minute periods.
• To see the other days of the week use the left /right arrow keys.
• Select the Add Schedule item to edit the calendar.
MAIN MENU
PROFILES
CURRENTLY ACTIVE 1
CALENDAR SETUP >
PROFILE OVERRIDE >
PROFILE MANAGER >
SYSTEM BEHAVIOR >
