AutoDome Easy II IP Troubleshooting | en 129
Bosch Security Systems, Inc. Installation Manual F.01U.164.576 | 2.0 | 2010.03
17.1 AutoDome Easy II IP Operation and
Control
Malfunction Possible causes Recommended solution
No connection
between the unit
and terminal
program.
Incorrect cable
connections.
Check all cables, plugs,
contacts, terminals and
connections.
The computer's serial
interface is not
connected.
Check the other serial
interface.
Interface parameters
do not match.
If necessary select a different
interface and make sure that
the computer's interface
parameters match those of
the unit. Try the following
standard parameters: 19,200
baud, 8 data bits, no parity,
1 stop bit. Next, disconnect
the unit from the power
supply and reconnect it again
after a few seconds.
No image
transmission to
remote station.
Camera error. Connect local monitor to the
camera and check the camera
function.
Faulty cable
connections.
Check all cables, plugs,
contacts and connections.
Incorrect encoder
stream property set for
connection to
hardware decoder.
Select the H.264 BP+ (HW
decoder) option on the
Encoder Streams
configuration page.
