A SERVICE OF

logo

ASSEMBLY
RMB 1865 11/10 Assembly Section 3-7
© 2010 Alamo Group Inc.
ASSEMBLY
The four levers of machine controls must be operated from the tractor seat. During this
operation ensure no one is standing on or among the linkage arms or bars. Set tractor
hydraulics to position control. Never allow anyone below the frame unless it is securely
blocked up.
Check the welded in pins between the stabilizers jaws are in contact with the mounting rail. If not the machine
must be lowered to the ground and the next higher hole on the stabilizer valve selected, the machine raised
and contact checked. Repeat again in the third hole if necessary. On subsequent fitting to the same tractor the
hole selected is always used.
Adjust the top link to bring the frame of the
machine into the vertical position.