20060601
3-1
Controlling the Appearance of the Geometry Window
3. Controlling the Appearance of the Geometry
Window
This section provides information about how to control the appearance of the screen by
scrolling or zooming, and by showing or hiding axes and the grid.
Displaying Axes and the Grid
Use the following procedures to turn display of the axes and grid on or off.
u To specify the axis setting
1. Press !m(SET UP) to display the Setup screen.
2. Use the following key operations to select the setting you want.
To select this setting: Press this key:
Axes on
1(On)
Axes off
2(Off)
Axes with scale values on
3(SCALE)
3. After the setting is the way you want, press J.
Note
The scale values that are displayed after you select 3(SCALE) in the above procedure will
be the outermost scale on each of the axes (x and y). Note, however that scale values will
not be displayed if the outermost values are outside of the display range.
