25
Error Code
categDetai
Error Message Description Remedy
0x040x00ReadOnlyFileAccessError Write is specified to read-only-file. Change the file attribution for
write.
0x050x00CommunicationError Communication error. See note 1.
0x050x03SpawnError Spawn error. See note 1.
0x050x04CommandTimoutError Command timeout error. See note 1.
0x050x05ErrorOpeningErrorLogFile Fail to open log file. Check if the path name of log file
is correct.
0x050x06OptionError Option error. Check if the selection of operation
is correct.
0x050x07StartupError Startup error. Check if other application is using
the COM port.
0x050x08OpenError Open error. See note 1.
0x050x09ListenError Listen error. See note 1.
0x050x0AAcceptError Accept error. See note 1.
0x050x0BNotEnoughMemoryToExecuteProcessMemory is not enough. Close other applications first.
0x050x0CArgumentListTooLargeForTheProcessProcess is too long. See note 1.
0x050x0DInvalidModeForTheProcess Child-process ends illegally. Check the operation method.
0x050x0EProcessTerminatedNormally Child-process ends normally. Normal end.
Er
ror
0x050x0FNoiseError Communication noise error. See note 1.
Table 4.2 Error codes and error messages
Note:
1. First make sure the connection of each option is complete and each component is
powered properly. Next, restart the system and execute the process again. If the same error
occurs again, reduce the baud rate before retrying. If normal operation cannot be achieved even
after making the above adjustments, contact your nearest support/technical center.
2. The file could not be properly accessed. Check if the file can be properly accessed or if the
disk is full.
