PAC 510, 515, 520 Installation Instructions
6
Accessory Box Installation
1. Insert accessory box into opening, if installing PAC510 or
PAC515, or position PAC520 in desired mounting location.
Figure 2
WARNING: ELECTRICAL SHOCK HAZARD! CUTTING
OR DRILLING INTO ELECTRICAL WIRES OR
CABLES CAN CAUSE DEATH OR SERIOUS
PERSONAL INJURY! ALWAYS make certain area behind
mounting surfaces is free of electrical wires and cables
before cutting, drilling, or installing fasteners.
2. Secure accessory box to studs by:
WOOD STUD:
1. drill four 3/16" dia. pilot holes in studs at mounting
holes.
2. install four M4 x 40mm Allen head connector screws
into pilot holes using an M4 Allen head drill bit
(provided).
STEEL STUD:
1. drill four 3/16" dia. pilot holes in studs at mounting
holes.
2. install four 1/4" countersunk finishing washers and
four 1/4" x 2" Phillips flat head self drilling screws
into pilot holes.
NOTE: When installing PAC520 in configuration B the quantity
of hardware changes to three for both wood and steel
stud installations.
Figure 3
x3
(3/16" dia. Pilot)
(Steel Stud Only)
x4
(3/16" dia. Pilot)
(Steel Stud Only)
(Steel Stud Only)
(C) x4
(Steel Stud Only)
(B) x4
(C) x4
(C) x4
(Steel Stud Only)
(Steel Stud Only)
(B) x4
(C) x4
(Steel Stud Only)
(Steel Stud Only)
(B) x4
(C) x4
(C) x4
PAC510 and PAC515
PAC520
