4
3. Safety Information
3.3 WARNING: Read through the entire instructions before attempting installation.
• Risk of electrical shock - This pump is supplied with a grounding conductor. To
reduce risk of electrical shock, connect only to a properly grounded, grounding type
receptacle.
• Plug the unit into a dedicated, fused circuit.
• Install pump on a flat, level, solid foundation. This pump is non-submersible.
4.4 CAUTIONS:
• Pump warranty is voided by failure to use factory- supplied filter on water
supply! Water filter is installed on water INLET line! (See section 5.3 for more
details.)
• To reduce risk of electric shock, disconnect power before servicing this pump.
• Maximum design pressure is 800 PSI (55 bar) continuous. Under no circumstances
should the pressure be allowed to go higher than 1000 PSI (69 bar).
• This pump has been evaluated for use with water only. Do not use with any other
liquids.
• To reduce risk of electric shock, install with all electrical components well-grounded
and dry.
4. Grounding Instructions
4.1 The pump should have a dedicated circuit
4.2 The pump MUST BE GROUNDED! In the event of a malfunction or breakdown,
grounding will reduce the risk of electric shock by providing a path of least resistance
for the electric current. Install electrical hookup in accordance with all local codes and
ordinances. Warning: Improper connection of the equipment-grounding conductor can
result in a risk of electric shock. Check with a qualified electrician if you are in doubt
whether the pump is properly grounded. Never use a two-prong outlet or cut off the
third prong on the plug!
