C–2 Troubleshooting Guide
Drive Protection System (DPS)
Accessing DPS Through Compaq Diagnostics for Windows
To access DPS through Compaq Diagnostics for Windows, perform
the following steps:
1. Turn on the computer and select My Computer > Control
Panel > Compaq Diagnostics.
A choice of five possible headings appears in the Diagnostics
screen: Overview, Test, Status, Log, and Error.
2. Select Test > Type of Test.
A choice of three tests appear: Quick Test, Complete Test, and
Custom Test.
3. Select Custom Test.
A choice of two test modes is offered: Interactive Mode and
Unattended Mode.
4. Select Interactive Test > Storage > Hard Drives.
5. Select the specific drives to be tested > Drive Protection System
Test > Begin Testing.
When the test has been completed, one of three messages will be
displayed for each of the drives tested:
■
Test Succeeded. Completion Code 0.
■
Test Aborted. Completion Code 1 or 2.
■
Test Failed. Drive Replacement Recommended. Completion
Code 3 through 14.
If the test failed, the completion code should be recorded and reported
to your service provider for help in diagnosing the computer problem.
177620-006.book Page 2 Thursday, March 14, 2002 3:16 PM
