1-6 Platform Guide
www.dell.com | support.dell.com
2600 PCI slot 1 is 32 bit,
33 MHz.
Bus 2: PCI/PCI-X
slot 7 is hot-
pluggable 64 bit,
up to 133 MHz.
Bus 3: PCI/PCI-X
slot 6 is hot-
pluggable 64 bit,
up to 133 MHz.
Bus 4: PCI/PCI-X
slots 4 and 5 are
hot-pluggable
64 bit, up to
100 MHz.
Bus 5: PCI/PCI-X
slots 2 and 3 are
hot-pluggable
64 bit, up to
100 MHz.
Install in any available
PCI slot.
NOTE: Install PERC
3/DC and PERC 3/QC
expansion cards in PCI-X
expansion card slots 2–5.
Dell recommends that
you do not install PERC
3/DC and PERC 3/QC
expansion cards in slots 6
and 7.
Install in any available PCI slot. NA
2650 Three 64-bit
PCI/PCI-X slots are
located on the riser
card (two slots on
bus 1 and one slot
on bus 2). Slots
accept full-length
cards designed for
PCI-X up to
133 MHz.
Install in any available
PCI slot.
Install in any available 64-bit PCI slot.
NOTE: For systems using Windows
NT 4.0, Enterprise Edition, adding
and removing a PERC 3/DC expansion
cards requires that drivers for the
onboard NIC be installed.
NA
4400 Bus 1: PCI slots 1
and 2 are 64 bit,
33/66 MHz.
Bus 2: PCI slots 3
through 6 are
64 bit, 33 MHz.
Bus 3: PCI slot 7 is
32 bit, 33 MHz.
Install in any available
64-bit, 33-MHz or 32-bit,
33-MHz PCI slot.
Install in any available PCI slot.
Dell recommends installing Emulex
cLAN adapters in 64-bit slots.
If you are currently
using a DRAC II
or plan to use one
in the future,
install the DRAC
II in PCI slot 7.
Table 1-3. PCI/PCI-X Slot Assignments for PowerEdge Cluster Nodes
(continued)
PowerEdge
System
PCI Buses RAID Controller NICs DRAC II or III
