A SERVICE OF

logo

Page 8 of 28 RD0169 (A) KF730 & SB730 OWNER’S MANUAL
When flown as part of a KF730 array, the SB730s should be the uppermost enclosures in the
array. In this application, the SB730s are suspended flat-fronted, with the KF730s suspended
below in the curvature determined by the KF730 Wizard.
When flown separately, SB730s should be flown so that the spacing between the line of SB730
enclosures and KF730 enclosures is about 1 ft / 0.3 m. The SB730 should be suspended in a flat-
fronted configuration.
4.4.4 Other Subwoofers
Other subwoofers, such as the EAW’s SBX220, SB600z SB1000z, or BH760, can also be used
with KF730s. Recommended quantities of KF730 for each subwoofer are:
Model Subwoofer KF730
SBX220 2 3
SB600z 1 2
BH760 1 4
SB1000zR 1 2
4.4.5 Signal Delay on Subwoofers
If SB730s are flown or stacked with KF730s as configured in the KF730 Wizard, use the factory
signal delay settings.
For other configurations or subwoofers, it will usually be necessary to determine the signal delay
settings by measurement.