EPSON AcuLaser C1100 Revision B
PRODUCT DESCRIPTION Control Panel 52
PRINTER ADJUST MENU
Note *1: Displayed only when the Support Mode has been selected by a special operation
when the power is turned on.
After changing the settings in the Printer Adjust Menu and pressing the Enter button,
the printer reboots.
*2: Displayed only when the Support Mode has been selected by a special operation
when the power is turned on.
After changing the settings in the Printer Adjust Menu and returning to the menu, the
printer reboots.
*3: After finished calibrating, the printer directly goes back to the normal operating
mode.
Maintenance Menu
Note *1: Displayed only when the Maintenance Mode has been selected by a special
operation when the power is turned on.
*2: Pressing the Enter button leaves the panel settings.
*3: Pressing the Enter button reboots.
Setting Value
Normal*
1
0 ~ 5 ~ 15
SemiThk*
1
0 ~ 5 ~ 15
Thick*
1
0 ~ 5 ~ 15
ExtraThk*
1
0 ~ 5 ~ 15
Card*
1
0 ~ 5 ~ 15
Envelope*
1
0 ~ 5 ~ 15
Feed Offset*
2
-3.5 to 0.0 to 3.5 mm
Scan Offset*
2
-3.5 to 0.0 to 3.5 mm
Feed Offset2*
2
-3.5 to 0.0 to 3.5 mm
Scan Offset2*
2
-3.5 to 0.0 to 3.5 mm
Calibration*
3
C H E C K
P O I N T
Secondary transfer voltage adjust value, from plain paper to
envelop, becomes same value between front side and reverse
side.
When printing both sides, offset value for reverse side is
displayed regardless of Duplex unit is installed or not.
C A U T I O N
Before using this function, refer to the instructions given in “1.15.3
Explanation of Menu and Settings” (p.54).
Setting Value
Engine Status Sheet*
1
*
2
---
Print Log Report*
1
*
2
---
Reset 2ndBTRCounter*
1
*
3
---
Reset C DvlpCounter*
1
*
3
---
Reset M DvlpCounter*
1
*
3
---
Reset Y DvlpCounter*
1
*
3
---
Reset K DvlpCounter*
1
*
3
---
Reset Fuser Counter*
1
*
3
---
Clear Error Log*
1
---
MCU DATA BackUp*
1
*
2
---
MCU DATA Restore*
1
*
3
---
