4-15
IPL 250 • SIS Programming and Control
Command/response table for SIS commands (continued)
Command ASCII (Telnet)
(host to IPL)
URL Encoded (Web)
(host to IPL)
Response
(IPL to host)
Additional description
Set GMT offset
24
E X#
CZ
}
W
X #
CZ| Ipz
X # ]
Set the Greenwich Mean Time (GMT) offset
value (
X#
) for the IPL’s location. GMT
offset (-12.00 to +14.00) represents the time
difference in hours and minutes (+/-hh:mm)
relative to Greenwich, England. The leading
zero is optional. For example, 5:30 = 05:30.
Do not use a plus (+) sign if the GMT offset
is positive.
Read GMT offset
E
CZ
}
WCZ
| X#
]
Set daylight saving time
24
E X3$
C X
}
W
X3$
CX
|
Ipx
X3$
]
X3$
= Daylight saving time (DST) is a region-specific 1-hour offset that begins in spring and ends in fall.
0 = off/ignore
1 = USA on – Starting in 2007, DST begins on the second Sunday of March at 2 AM and ends at 2 AM on the first Sunday of November.
For example, time in California is GMT -8:00 from March to November and GMT -7:00 from November to March. However, DST should
be turned off in Hawaii, American Samoa, Guam, Puerto Rico, the Virgin Islands, the eastern time zone portion of the state of Indiana,
and the state of Arizona (excluding the Navajo Nation).
2 = Europe on – begins on the last Sunday in March, ends on the last Sunday in October. DST should be turned off for Iceland.
Read daylight saving time
E
CX
}
W CX
| X3$
]
Set DHCP on
24
E
1
DH
}
W1DH
|
Idh
1
]
Set DHCP off
24
E
0
DH
}
W0DH
|
Idh
0
]
N
Changing DHCP from on to off also resets the IP address to the factory default (192.168.254.254).
View DHCP mode
E
DH
}
WDH
| X%
] X%
= 0 (off) or 1 (on).
Set IP address
24
E X1$
C I
}
W
X1$
CI| Ipi•
X1$
] X1$
= IP address (xxx.xxx.xxx.xxx). Leading
zeros in each of the four fields are optional
in setting values.
Read IP address
E
CI
}
W CI
| X1$
]
Leading zeros in each of the four fields are
suppressed in returned values.
Read hardware address (MAC)
E
CH
}
WCH
| X1*
]
orIph•
X1*
]
X1*
= hardware (MAC) address (xx-xx-xx-
xx-xx-xx).
Set subnet mask
24
E
X1(
CS
}
W
X1(
CS
|
Ips•
X1(
] X1(
= subnet mask (xxx.xxx.xxx.xxx).
Syntax is the same as for IP addresses.
Leading zeros are optional in setting values.
Read subnet mask
E
CS
}
WCS
| X1(]
Leading zeros are suppressed.
Set gateway IP address
24
E
X1$
CG
}
W
X1$
CG
|
Ipg•
X1$
] X1$
= IP address (xxx.xxx.xxx.xxx).
Leading zeros are optional.
