STEP 1 – Vertical Column Installation
a) Lift Vertical Column Tube and insert into Base
Frame Assembly, see Figure 1. When lifting and
inserting Vertical Column Tube DO NOT cut
wires. Note: It is critical to line up sticker on
Vertical Column Tube with sticker on Base
Frame Assembly to ensure proper alignment.
b) Insert (6) Allen Bolts, (6) Spring Washers and
(6) Curved Washers from fastener pack. Tighten
bolts with Allen Wrench provided.
STEP 2 – Roller and End Cap Installation
a) Carefully lay unit on its left side and remove shipping plugs with a standard screwdriver.
b) Align notches in Roller and Front Floor Tube, push down to insert Roller into Front Floor Tube.
Secure using (1) Phillips Screw and tighten, see Figure 2.
c) Align notches in End Cap and Rear Floor Tube, push down to insert End Cap into Rear Floor
Tube. Secure using (1) Phillips Screw and tighten.
d) Lay unit on its right side and install Roller and End Cap by repeating Steps 2b and 2c.
e) Stand unit upright.
