FOAMPRO® F1000
28
©2001 R11.01
1 | Before removing the Air Cylinder/Piston Assembly (D400) from the F1000,
first be sure that the Connecting Rod (D405) is fully extended out from the Air
Cylinder Body (D401). This would be its normal position when the F1000 is NOT
dispensing foam.
(See diagram 29A)(See diagram 29A)
(See diagram 29A)(See diagram 29A)
(See diagram 29A)
2 | On the Air Injection System, disconnect the plastic tubing where it enters
the air fitting on the side of the Mix Cartridge (D603 or other optional Mix
Cartridge) Do this by loosening the ferrule connection on the Tubing Elbow
(D706) and slipping the Plastic Tubing (D708) out of the ferrule. It is not neces-
sary to remove the Tubing Elbow (D706) from the Mix Cartridge (D603).
(See diagram 29B)(See diagram 29B)
(See diagram 29B)(See diagram 29B)
(See diagram 29B)
3 | Rotate the Air Injection System so that it is perpendicular to the Handle
(D201). This is done to provide clearance for removal of the Air Cylinder/Piston
Assembly (D400).
(See diagram 29B)(See diagram 29B)
(See diagram 29B)(See diagram 29B)
(See diagram 29B)
MAINTENANCE | SERVICE
3.1.3
Air Cylinder/ PistonAir Cylinder/ Piston
Air Cylinder/ PistonAir Cylinder/ Piston
Air Cylinder/ Piston
Assembly (D400)Assembly (D400)
Assembly (D400)Assembly (D400)
Assembly (D400)
