A SERVICE OF

logo

Open as PDF
next previous
OPERATION
16
MTF--051058L
HOW TO USE THE WHEEL LOCKOUT
Each wheel is secured to the axle with a lockout pin. See
Figure 14. The unit was shipped with the lockout pin in the
locked position. For ease of maneuverability, disconnect the
lockout pin as follows.
1. Pull the knob out to disengage the lockout pin.
2. To lockin thedisengaged position,turn theknob 1/4turn
(90 degrees).
Figure 14
Knob
Wheel Lockout
HOW TO SET THE DRIFT CUTTERS
(OPTIONAL ACCESSORY ON SOME MODELS)
Drift cutters are used to cut a path through snow deeper than
the auger housing.
1. Loosen the wingnuts that secure the drift cutters to the
auger housing (see Figure 15).
2. Raise the drift cutters to the desired height.
3. Tighten the wingnuts.
Drift Cutter
Wingnut
Figure 15