GPSMAP 5000 Series Owner’s Manual 41
Conguring the Device
ConfiGUrinG
the deViCe
Fuel Capacity—enter the total fuel capacity of all your engines.
To adjust the Keel Offset:
1. From the Home screen, touch Congure > My Boat > Keel Offset.
2. Using the on-screen keyboard, enter the measured distance from the transducer location to the
water line or to the keel of the boat.
If you are measuring down to the keel (transducer installed at the water line), enter a (+)
positive number. This shows the depth at the bottom of the keel.
If you are measuring up to the water line (transducer installed on the bottom of the keel), enter
a (-) negative number. This shows the depth at the surface.
3. Touch Done to accept the number.
Transducer at the water line
Transducer at
the bottom of
the keel
Keel Offset
A (+) positive number
shows depth at the bottom
of the keel.
A (-) negative number
shows depth at the surface.
Conguring Other Vessels
NOTE: To congure Automatic Identication System (AIS) or Digital Selective Calling (DSC)
information for other boats, your chartplotter must be connected to an external AIS or DSC device.
From the Home screen, touch Congure > Other Vessels.
AIS
—turn AIS on or off. AIS alerts you to area trafc by providing boat IDs, position, course, and
speed for boats that are within range and equipped with a transponder.
DSC—turn DSC on or off.
Collision Alarm
(AIS and MARPA only)—turn a safe zone around your boat on or off. This is used
for collision avoidance and can be customized.
To customize safe-zone settings:
From the Home screen, touch Congure > Other Vessels > Collision Alarm.
Range—change the measured radius of the safe zone ring to a specied distance from 500 ft.
to 2.0 nm (or from 150 m to 3.0 km, or from 500 ft. to 2.0 mi.).
Time to (Safe Zone)—sounds an alarm if AIS or MARPA determines that a target will
intersect the Safe Zone within the dened time interval (ranging from 1 to 24 minutes).
•
•
•
•
