Conguring the Chartplotter
50 GPSMAP 400/500 Series Owner’s Manual
1. From the Home screen, select > >
> > .
2. Select the type of tank you want to label.
3. Select .
4. Select a tank.
3. Select the location of the tank: , , ,
, or .
4. Select the label you want to use for the tank.
You can set the unit to sound an audible alarm when certain conditions are met.
By default, all alarms are turned off.
1. From the Home screen, select > .
2. Select an alarm category.
3. Select an alarm.
4. Select to turn on the alarm.
5. Specify alarm information.
To set a navigation alarm from the Home screen, select >
> .
—set an alarm to sound when you are within a specied distance or
time from a turn or a destination waypoint.
• —select whether you want arrival alarms to sound only when nearing
destinations or when nearing either turns or destinations. Select to
disable arrival alarms.
• —select whether the arrival alarm triggers on time to arrival or
distance to arrival.
• —if you have Activation set to Time,
select to set the number of minutes before arrival that the
alarm should sound. If you have Activation set to Distance, select
to set the distance before arrival that the alarm should sound. Use
the to change the time or distance.
—set an alarm to sound when you exceed a specied drift
distance.
—set an alarm to sound when you are off course by a specied
distance.
To set a system alarm from the Home screen, select >
> .
—set an alarm using the system (GPS) clock. The unit must be on for
the clock alarm to work.
—set an alarm to sound when the battery reaches a specied low
voltage.
—set an alarm to sound when the GPS location accuracy falls
outside the specied value.
