Oregon Series Owner’s Manual 37
Appendix
Notice
Do not try to navigate using Demo
mode because the GPS receiver
is turned off. Any satellite signal-
strength bars shown are only
simulations and do not represent the
strength of actual satellite signals.
To turn Demo Mode on, touch Setup
> System > GPS > Demo Mode.
Connecting Your Oregon
to a Computer
You can connect the Oregon to your
computer using the supplied USB
cable.
To connect your Oregon to your
computer:
1. Lift the weather cap on the bottom
of the Oregon.
2. Insert the smaller connector on
the USB cable into the mini USB
connector.
3. Connect the other end of the
cable to a USB port on your
computer.
Installing a microSD
Card
The Oregon microSD card tray is
located beneath the AA batteries.
Purchase microSD cards from an
electronics supplier or purchase
preloaded MapSource
®
detailed map
data cards from your Garmin dealer.
Go to http://buy.garmin.com for
compatible map products.
To install or remove a microSD
card:
1. Lift the latch on the back of the
Oregon (page 2), and remove the
battery cover and the batteries.
2. Lift the metal cover.
3. Push the card into the microSD
card tray, and close the metal
cover.
