24
%:7=+4.;177<260%28;
$*>.<25.*6-576.A#.>2.?<1.,1*:<;76<1./7447?2608*0.;
7:>2;2<<<85-:/1?/;9)7=5*A67<6..-<7,*44/7:;.:>2,.
#$" #;??5.81-A?1? )4-@&;;
>E1>?4-71?;> Some shaking/noise is normal. • Move dryer to an even floor space, or adjust leveling legs
9-71?:;5?1 Dryer may be sitting unevenly as necessary until even.
8;@41?@-71@;;8;:3 Improper or obstructed ducting • Check the Installation Instructions to make sure
@;0>E the dryer venting is correct.
• Make sure ducting is clean, free of kinks and unobstructed.
• Check to see if outside wall damper operates easily.
Improper sorting • Separate heavy items from lightweight items (generally,
a well-sorted washer load is a well-sorted dryer load).
Large loads of heavy fabrics • Large, heavy fabrics contain more moisture and take
(like beach towels) longer to dry. Separate large, heavy fabrics into smaller
loads to speed drying time.
Controls improperly set • Match control settings to the load you are drying.
Lint filter is full • Clean lint filter before every load.
Blown fuses or tripped circuit • Replace fuses or reset circuit breakers. Since most
breaker dryers use 2 fuses/breakers, make sure both are
operating.
Overloading/combining loads • Do not put more than one washer load in the dryer at
a time.
Underloading • If you are drying only one or two items, add a few items
to ensure proper tumbling.
&41$+0>E:1??81B18 Load consists of a mixture • When combining heavy and light fabrics in a load,
C-?/4;?1:.A@8;-05? of heavy and light fabrics choose "$$+.
?@5880-9<
Exhaust system is blocked • Inspect and clean exhaust system.
;:@>;8<-0?:;@ Controls accidentally put in • Press %&"#.
>1?<;:05:3 service mode
Controls accidentally put in • Hold the " button for 3 seconds to unlock the dryer.
lock mode
Controls performed an • Reset the in-house breaker.
incorrect operation
>E1>0;1?:L@?@->@ Control panel is “asleep” • This is normal. Press #")$ to activate the control panel.
Dryer is unplugged • Make sure the dryer plug is pushed completely into
the outlet.
Fuse is blown/circuit breaker • Check the building’s fuse/circuit breaker box and
is tripped replace fuse or reset breaker. !"&Electric dryers
use two fuses or breakers.
Dryer was accidentally paused • If the light on the +%&$& pad is flashing, the
when starting Delay Start dryer is paused. Press %&$& to restart the countdown.
!;:A9.1>?05?<8-E10 Dryer is continuously • This is normal. When the dryer senses a low level of
0A>5:3/E/81;:8E8534@? monitoring the amount of moisture in the load, the dryer will display the dry time
moisture in the clothes remaining.
12;>1E;A/-882;>?1>B5/1G <<85-:/1?/;9
;:?A91>%A<<;>@&>;A.81?4;;@5:3&5<?"<1>-@5:3:?@>A/@5;:?%-21@E:?@>A/@5;:?
