Step 9
~imble (aRati totie wdl orfloor)
FlexDud
Blowe
Scr
L~Ho” C’amp
>*
Blower
1. Removethe screw in the front of the blower
transition separating the blower transition from
the blower housing.
2. Placethe hose clamp around the round end of
the blower transition. Attach the flexduct to the
blower transition using the hose clamp.
3. With the anti-tipbracket properly instied in
the floor,place the long end ofthe thimble hto
the wd and screw it into place using the four
screws provided, one in each corner.
4. Placethe hose clamp provided around the
short end ofthe thimble. Attach the opposite end
ofthe flex duct to the short end of the thimble
using the hose clamp.
5. Plug the range into the wd.
6. CarefuUypush the range back into position.
Avoidpinching the transition piece or flexduct
7. Using the guide screw to locate the hole in
the rear of the blower housing, position the
transitionhside the blowerhousing.Rotatethe
transitionunti the holeinthe frontofthe blower
housingis tigned. Securethe transitionwiththe
screwprovided.
8. Sed auductjointswithducttape.
9. Checkunderthe rangeto be sure the levehg
legisfullyengagedin the anti-tipbracket
10. hsti the storagedrawer.
Fii Duct Connection tiou@ the moor
e
1. Attachthe rubbergasket
\
aroundthe edge ofthe
transitionpiece.me flatside
/“\.
ofthe rubbergasket should
--
be on the underside ofthe
transitionpiece.
2. Placethe roundendtransitionpieceintothe
floor.Securethe transitionpieceusingthe 8
screwsprovidedin tie kit YoumustM the edge
ofthe rubber gasketto installthe screws.Make
surethe roundedgeofthe gasketis facingup.
3. Insertthe floorelbowductintothe transition
piece.me tide flze must face
towardthe
front of the -e. Attach the floor elbow duct
to duct plate using the two screws provided.
Tighten onlythe front screw.
4. Attach the floor elbow duct to the blower
using the 8 screws provided. me floor elbow
duct should be inside the blower.
5. Plug the range intothe wd.
FloorElbow
Blower
Duet\
/
tape,
TranstionPie@
\ FloorPlate
6. Pushthe rmge intoposition.Makesure
thatthe floorelbowductis directiyoverthe
transitionpieceandrubber gasket me rubber
gasketfi providea sed be~een the floor
elbowandthe transitionpiece.Seethe above
Uustration.
7. hosen the frontscrewattachingthe floor
elbowductplateandthe floorelbowduct Sfide
the floorelbowductplatedowntightagainstthe
rubbergasketandtightenthe screw.
8. Sed thejointbetweenthe blowerandelbow
trmsitionpiecewithducttape.Checkunderthe
rangeto ensurethe anti-tipbracketis engaged.
9. Insti the storagedrawer.
54
