A SERVICE OF

logo

17
4. The camera/terminal will redisplay with the new
information.
5. Pressing the enter key will terminate the camera/terminal
IP set-up and return you to the previous menu.
Figure 9. The camera/terminal IP table
Option #3 lets you enable/disable the Use IP for Camera
command. When set to Enabled the PBe will search the
incoming UDP and TCP packets for a match of IP addresses.
Depending on the Device setting the PBe will parse the data
received in that packet and send it to the associated camera
number.
The Monitor Mode menu
The fourth selection on the Main Menu is the Monitor Mode on/
off toggle. This selection will toggle between off and on when 4