12
10. Attach the Butterfly Frame Brace (6) to the
Upright (2) with two M8 x 80mm Bolts (100), two
M8 Washers (103), and two M8 Nylon Locknuts
(78). Do not tighten the Nylon Locknuts yet.
11. Apply a small amount of the included grease in
the locations shown. Insert a 56.5mm Spacer (69)
into the indicated hole in the Leg Lever (12).
Attach the Leg Lever to the Front Leg (10) with
an M10 x 61mm Bolt Set (116).
Make sure that
the barrel of the Bolt Set is inserted through
both sides of the bracket on the Front Leg.
Make sure that the indicated rod is oriented as
shown.
See the left inset drawing. Attach the Lock Plate
(14) to the Front Leg (10) with the M8 x 69mm
Shoulder Bolt (87), an M8 Washer (103), and an
M8 Nylon Locknut (78).
See the right inset drawing. Insert the Lock
Plate Pin (95) through the Lock Plate (14) and the
Leg Lever (12). Attach the tether on the Lock
Plate Pin to the Front Leg (10) with an M4 x
12mm Self-tapping Screw (102).
Arm Assembly
10
78
6
2
103
100
100
11
10
Rod
12
Hole
116
102
103
87
14
10
78
95
14
12
69
116
Grease
Grease
10
