6
2
33
1
32
3. Attach the Bench Frame (2) to the Cross Frame
(1) with two M10 x 68mm Bolt (33) and two M10
Nylon Locknuts (32). Do not tighten the
Locknuts yet.
4. Press a 50mm x 100mm Inner Cap (17) into the
top of an Upright (5).
Orient the Upright (5) with a decal applied to it, so
that the adjustment holes are on the indicated
side. Attach the Upright to the Cross Frame (1)
and a Large Support Plate (12) with two M10 x
68mm Bolts (33) and two M10 Nylon Locknuts
(32).
Repeat this step with the other Upright (5).
Tighten the M10 Nylon Locknuts (32) used in
steps 1–4.
3
16
16
6
5
28
5. Press two Weight Rest Bushings (16) into the top
and bottom of a Weight Rest (6).
Pull the Weight Rest Knob (28) out as far as it will
go and slide the Weight Rest (6) onto an Upright
(5). Engage the Knob into an adjustment hole in
the Upright.
Repeat this step with the other Weight Rest
(6). Set both Weight Rests at the same height.
5
17
1
12
32
33
5
Adjustment
Holes
Decal on
this Upright
4
