Removing more than
1
⁄16" from the infeed
fence may greatly increase the risk of kick-
back injury when routing.
7.
Step 5
8.
Figure 30
HigV^\]iZY\Z
Dji[ZZY
;ZcXZ7dVgY
HigV^\]i
GdjiZg7^i
>c[ZZY
;ZcXZ7dVgY
IdeK^Zl
Figure 30.
9.
Figure 31
IdeK^Zl
8jii^c\9^gZXi^dc
Figure 31.
Always feed the workpiece against the rout-
er bit rotation direction, as illustrated below.
Otherwise, the workpiece could be aggres-
sively pulled from your hands, drawing
them into the spinning cutter.
Step 8
6.
Step 5
