Grizzly T10125 Manual

Open as PDF

next previous





       

        

Figure 10.

Figure 10.



HigV^\]iZY\Z

Dji[ZZY >c[ZZY

       



       

       

  

     

       



19.       



20.       





      



21. 

        





        



Installing or adjusting a carbide cutter:

1. 

2.        



3. 

4.         

    

       



 Note:Proper cleaning is critical to achieving

a smooth finish. Dirt or dust trapped between

the insert and cutterhead will slightly raise the

insert, and make noticeable marks on your

workpieces the next time you cut.

5.       

        

  



 Note: Excess oil may squeeze between the

insert and cutterhead or in the screw hole,

thereby lifting the insert or screw slightly and

affecting workpiece finishes.

Figure 11.





Insert Service







       



Figure 11