KK-F-VAK_INST_10-08
3
Align the assembly so the hole in
the assembly lines up with the “J
clip”. Re-attach using the hex
head lag bolt removed earlier
At the intake side of the OEM
unit, attach the hose plate as
shown above using (2) #10 x ¾”
sheet metal screws
Attach the (2) #10 x ¾” sheet
metal screws at the location
shown above. Pre-drill 1/8” hole
Route hose straight up from the HVAC
unit and tie tight to the corner of the van
Tighten the clamp that holds the
hose to the assembly
Now the HVAC adapter kit is
fastened to the OEM unit.
When routing the hoses, tie together
using 15” wire ties, to keep a neat and
tight fit to the wall of the vehicle. This
will minimize the risk of damage when
installin
Kwik-Kit
Attach the intake hose and clamp
to the HVAC adapter box
