
Quick Reference Service Manual
15
HP DesignJet 2500CP and 2000CP Printers
C09. Maintenance
Purpose Ć To read and, if necessary, adjust the preventive maintenance counter, which counts
the number of swaths.
This Calibration must be used to reset the Maintenance counter to ZERO
after the Preventive Maintenance Kit has been installed in order to disable
the Maintenance Advised" message on the frontĆpanel.
Note down the Swaths Counter (####) before replacing the Electronics Module.
Adjust the Swaths Counter (####) after replacing the Electronics Module.
Use the following keys to adjust the swaths counter.
D Up Arrow Ć Increase the Counter Digit.
D Down Arrow Ć Decrease the Counter Digit.
D Enter Ć Select the Next digit.
C10. Font Type Set (Only available in HP DesignJet 2500CP printer)
Purpose Ć To check and, if necessary, select a Font type (only possible when the printer
detects that a new Hard Disk has been installed).
YOU MUST PERFORM THIS CALIBRATION WHEN YOU INSTALL A NEW
ELECTRONICS MODULE IN ORDER TO SET THE CORRECT FONT TYPE.
If you have not installed a new Electronics Module, current font type will be displayed.
If you have installed a new Electronics Module, Character Set New" will be displayed. Press
Up Arrow key to set new type font.
The message Choose Character Set" will be displayed on the frontĆpanel. Use Up and
Down Arrow keys to select font type required and then press Enter.
The first time a PostScript print is sent to the printer, the other font types will be deleted
and cannot be recovered.
IF YOU DO NOT SELECT ANY FONT SET, THE ROMAN FONT WILL BE
SELECTED BY DEFAULT WHEN A POSTSCRIPT FILE IS SENT.