2.2 HP-GL Mode Menu Settings 17
Quantity Setup
Sets the method to specify the number of copies to print. Candidate values are shown
below.
[Protocol] (default)
[Stored Jobs]
[Command]
2 Sided Print
Sets 2 sided printing.
[Off]
2 sided printing is not done.
[Long Edge Flip]
Printing is done from left to right.
[Short Edge Flip]
Printing is done from top to bottom.
Note
• Can be set when the duplex unit (optional) is installed.
Output Tray
Specifies the tray to which the printed paper is ejected.
[Center Tray] (default)
[Rear Tray]
[OffsetCatchTray]
Note
• You can set [Rear Tray] when the optional rear tray is installed.
• You can set [OffsetCatchTray] if the optional offset catch tray is installed.
Adjust Position
Moves the hard clip area vertically or horizontally. This setting can be made in 1 mm
increments within the range between -250 and +250.
[Up & Down]
You can set this item in 1 mm increments from -250 to 250mm. (-9.8 to 9.8 inches in 0.1
inch increments)
The default value is [0 mm].
[Left & Right]
You can set this item in 1 mm increments from -250 to 250mm. (-9.8 to 9.8 inches in 0.1
inch increments)
The default value is [0 mm].
Note
• Data outside the print area will not be printed even if the position is adjusted.
• Data that has gone out of the print area as the result of positional adjustment will not be printed.
• When changing the candidate values by the < > or < > button, you can change the display
continuously by holding the button down. Also, pressing the < > and < > buttons simultaneously
displays the default value.
