
To set the auto continue
1. Press M
ENU
to enter the MENUS.
2. Press
to highlight Configure Device.
3. Press
to select Configure Device.
4. Press
to highlight SYSTEM SETUP.
5. Press
to select SYSTEM SETUP.
6. Press
to highlight AUTO CONTINUE.
7. Press
to select AUTO CONTINUE.
8. Press
or to select the appropriate setting.
9. Press
to set the selection.
10. Press M
ENU
.
Supplies low
The printer allows two options for reporting that supplies are low; CONTINUE is the default
value.
● CONTINUE allows the printer to continue printing while displaying a warning until the
supply is replaced or a supply out condition is reached.
● STOP causes the printer to pause printing until you replace the used supply or press
,
which allows the printer to print while continuing to display the warning.
To set supplies low reporting
1. Press M
ENU
to enter the MENUS.
2. Press
to highlight Configure Device.
3. Press
to select Configure Device.
4. Press
to highlight SYSTEM SETUP.
5. Press
to select SYSTEM SETUP.
6. Press
to highlight SUPPLIES LOW.
7. Press
to select SUPPLIES LOW.
8. Press
or to select the appropriate setting.
9. Press
to set the selection.
10. Press M
ENU
.
44 Chapter 2 Control panel ENWW