
4-12 Control Panel for Large-Format Printers
• If you select
BOOTP=NO→,
the printer is configured to
accept TCP/IP parameters from the control panel.
Continue with step 4.
4. If you selected
BOOTP=NO→
, press
↑
to configure each TCP/IP
parameter. For example, to configure the IP address:
a. Press
↑
until
IP BYTE=0
is displayed. Press
[Enter]
.
b. Press
↑
or
↓
to select the number (0-255) for that byte, then
press
[Enter]
.
c. Press
↑
to select the next byte.
d. Continue the same process until all bytes are entered.
Note that a valid IP address is required for proper operation.
5. If appropriate, configure the subnet mask bytes (
SM
), syslog
server IP address (
LG
), default gateway (
GW
), and timeout
(
TIMEOUT
) in the same manner.
The
TIMEOUT
parameter default is 90 seconds. Up to
3600 seconds can be configured. If set to “0”, the timeout
feature of the HP JetDirect card is disabled—TCP/IP
connections remain open until closed by the server.
6. To save the configuration, press the
↑
and
↓
keys
simultaneously. A configuration page will print. Your
configuration is now active.
7. Press
[Previous]
until the
STATUS Ready
is displayed.
To manually configure other parameters, see the appropriate
sections in this chapter.
To complete the print server configuration, see the HP JetDirect
software installation guide
included with the product
.