Chapter 4 - Managing and configuring the printer66
To reset to factory default settings
NOTE: Using the following instructions will reset only the printer’s Bluetooth settings.
1. Press and hold down (Power button).
2. While holding down (Power button), press (Cancel button) 4 times, then press (Resume
button) 6 times.
3. Release (Power button).
To turn off Bluetooth
To turn off Bluetooth printing, remove the Bluetooth wireless printer card from the printer.
Bluetooth discovery
Discovery is the process by which a Bluetooth-enabled device detects other Bluetooth-enabled devices that
are within range.
When a device discovers the printer, it displays the printer’s Bluetooth device name. See Bluetooth device
name for more information.
The method of discovery varies according to the type of Bluetooth software used.
Bluetooth fonts
The printer ships with built-in fonts for Bluetooth printing. Certain models include Asian fonts for printing
from mobile phones. The fonts included depend on the country/region where the printer was purchased.
See Printer specifications.
Wireless configuration page
The wireless configuration page shows 802.11 and Bluetooth information you need when using the
printer. For more information and instructions on printing this page, see Understanding device information
pages.
Bonding
When a printer and a sending device bond, they store each other’s Bluetooth device address. This allows
the device to discover the printer in Private mode. See Private mode for more information.
The printer can bond to up to 31 devices. If you reach this limit and want to bond to an additional device,
you must clear all the previously bonded devices from the printer’s memory. See Reset device access for
instructions.
