54
No timer tick interrupt The timer chip has failed.
xxxxxh Option ROM checksum failure where xxxxxh is
the starting address of the option ROM
The peripheral card contains a defective ROM.
Shutdown failure Either the keyboard controller is not accepting the
reset command or the associated reset logic has
failed.
Time of day not set - run SETUP program Clock not set.
Timer 2 failure The timer chip has failed.
F2 to enter ROM-based SETUP Invalid configuration information must be changed.
Invalid configuration information - please run SET'UP Display adapter is configured incorrectly. Memory size
is incorrect. Wrong number of diskette drives. Other
configuration errors.
Keyboard clock line failure The keyboard, the keyboard cable connection, or the
keyboard controller is defective.
Keyboard data line failure- The keyboard controller firmware has failed.
Keyboard controller failure The keyboard controller firmware has failed.
Keyboard stuck key failure A key is jammed.
Memory failure at hex-value, read hex-value, expecting
hex-value
Circuitry associated with the memory chips has failed.
Unexpected interrupt in protected mode Hardware interrupt or NMI occurred while in protected
mode.
Real time clock failure The RTC or battery failed.
Message Possible Cause
nnnk Base Memory The amount of base memory that tested successfully.
nnnk Extended The amount of extended memory that tested
successfully.
Memory tests terminated by keystroke This message indicates that a user pressed the
spacebar while the memory tests were nmning and
stopped the memory tests.
Press the Fl key to continue This message indicates that an error was found during
POST. Pressing the Fl key allows the system to
attempt to boot.
Beginning memory test Press the SPACEBAR to
terminate the memory test
A user can stop the memory tests by pressing the
spacebar.
Press the Fl key to continue, F2 to nm the Setup utility This message indicates that an error was found during
POST. Pressing the Fl key allows the system to
attempt to boot. Pressing F2 allows users to run the
ROM-based Phoenix SETUP utility to correct
configuration information.
