16. Press to select DEFAULT GATEWAY.
Note The first of four sets of numbers are the default settings. Each set of numbers
represents one byte of information and has a range from 0 to 255.
17. Press the or arrow to increase or decrease the number for the first byte of the
default gateway.
18. Press
to move to the next set of numbers. (Press to move to the previous set
of numbers.)
19. Repeat steps 17 and 18 until the correct subnet mask is entered.
20. Press
to save the default gateway.
21. Press the P
AUSE/RESUME button to return to the Ready state.
Setting the syslog server
1. Press to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO X (where X = 1, 2, or 3).
7. Press
to select EIO X.
8. Press
to highlight TCP/IP.
9. Press
to select CONFIG METHOD.
10. Press
to select CONFIG METHOD.
11. Press
to highlight MANUAL.
12. Press
to select MANUAL.
13. Press
to highlight MANUAL SETTINGS .
14. Press
to select MANUAL SETTINGS.
15. Press
to highlight SYSLOG SERVER.
16. Press
to select SYSLOG SERVER.
Note The first of four sets of numbers are the default settings. Each set of numbers
represents one byte of information and has a range from 0 to 255.
17. Press the or arrow to increase or decrease the number for the first byte of the
default gateway.
18. Press
to move to the next set of numbers. (Press to move to the previous set
of numbers.)
19. Repeat steps 17 and 18 until the correct subnet mask is entered.
20. Press
to save the syslog server.
21. Press the P
AUSE/RESUME button to return to the Ready state.
EN_WW Network configuration 49
