A SERVICE OF

logo

After configuring the printer to feed paper from the
accessory,
load the photo paper into the accessory and then
follow the
PictBridge printing instructions.
Note:
For printing PictBridge photos, the printer only
needs to be configured to feed paper from the Auto
Two-Sided Print Accessory with Small Paper Tray
once. After being configured, the printer will
attempt to print from the accessory until the printer
is configured to use the In tray for PictBridge
photos.
Re-configuring the printer to feed paper from
the In tray
Follow these steps to re-configure the printer to feed paper
from the In tray for PictBridge photos:
1. Press and hold down the Report Page button.
2. While holding down the Report Page button, press the
Cancel button twice, and then press the Resume button
once.
3. Release the Report Page button.