NOTE:
This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on
configurable product offerings and requirements.
NOTE:
Factory Integrated Models must start with a CTO Server.
NOTE:
FIO indicates that this option is only available as a factory installable option.
NOTE:
All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives
ordered with the server.
Step 1: Base Configuration (choose one of the following configurable models)
HP Models
HP ProLiant DL320e Gen8 Hot Plug 4 LFF Configure-to-order Server
NOTE:
All 6G SATA/SAS Drives listed in HDD section are tested and supported for both
3G and 6G speed. A HP Smart Array Controller is required for 6G HDD.
675597-B21
Factory Integrated Model ships with:
1U Chassis with 4 LFF Hot Plug Drive Cage
HP Ethernet 1Gb 2-port 330i Adapter
HP iLO Management Engine (standard)
HP Dynamic Smart Array B120i SATA Controller (RAID 0/1/10)
NOTE:
For set up instructions for HP Dynamic Smart Array B120i SATA Controller please
refer to the HP ProLiant DL300 series server user guide
NOTE:
For general information about HP Dynamic Smart Array B120i SATA Controller,
please visit:
http://h18004.www1.hp.com/products/servers/proliantstorage/arraycontrollers/
smartarrayb120i/index.html
HP ProLiant DL320e Gen8 Hot Plug 8 SFF Configure-to-order Server
675598-B21
Factory Integrated Model ships with:
1U Chassis with 8 SFF Hot Plug Drive Cage
HP Ethernet 1Gb 2-port 330i Adapter
HP iLO Management Engine (standard)
HP Dynamic Smart Array B120i SATA Controller (RAID 0/1/10)
NOTE:
For set up instructions for HP Dynamic Smart Array B120i SATA Controller please
refer to the HP ProLiant DL300 series server user guide
NOTE:
For general information about HP Dynamic Smart Array B120i SATA Controller,
please visit:
http://h18004.www1.hp.com/products/servers/proliantstorage/arraycontrollers/
smartarrayb120i/index.html
HP ProLiant DL320e Gen8 Non-hot Plug 4 LFF Configure-to-order Server
NOTE:
All 6G SATA/SAS Drives listed in HDD section are tested and supported for both
3G and 6G speed. A HP Smart Array Controller is required for 6G HDD.
675596-B21
Factory Integrated Model ships with:
1U Chassis with 4 LFF Non hot plug Drive Cage
HP Ethernet 1Gb 2-port 330i Adapter
HP iLO Management Engine (standard)
HP Dynamic Smart Array B120i SATA Controller (RAID 0/1/10)
NOTE:
For set up instructions for HP Dynamic Smart Array B120i SATA Controller please
refer to the HP ProLiant DL300 series server user guide
NOTE:
For general information about HP Dynamic Smart Array B120i SATA Controller,
please visit:
QuickSpecs
HP ProLiant DL320e Generation 8 (Gen8)
Configuration Information - Factory Integrated Models
DA - 14326 North America — Version 21 — December 13, 2013
Page 19
