Setup 34
Complete the system setup
Check the status of the server LEDs to ensure that the server is operating normally:
• System power LED —Solid green
• NIC status LED —Solid green
• Drive status LED —Solid green
• Health LED bar—Solid blue
For server management tasks after the initial server setup, use either the dedicated iLO connector
(enabled by default) or the NIC 1/shared iLO connector (It is disabled by default. Enable the shared
iLO function in iLO RBSU).
For more information on iLO management tasks, see the HP website
(http://www.hp.com/go/ilomgmtengine/docs).
Registering the server
To experience quicker service and more efficient support, register the product at the HP Product Registration
website (http://register.hp.com).
Setting up the HP PS1810-8G Switch (optional)
If you intend to use the server with the companion HP PS1810-8G Switch, follow the procedures in this
section. For deployments requiring more than eight network ports, HP recommends using the HP
PS1810-24G Switch instead of the HP PS1810-8G Switch.
For more information on switch-related settings and operational procedures, see the documentation for your
switch model on the HP website (http://www.hp.com/networking/support).
