Unpacking and Assembly 1-21
46. Check the ground path between the spool and the finger that
protrudes from the end of the spool. If this fails, replace the
spool.
47. Check the ground path between the electronics box and the
supply & takeup assembly.
Touch one lead to the stainless steel pin located between the
two Phillips-head screws above the spool collet on the
takeup. Place the other lead on the stainless steel cover of
the electronics assembly. If this fails, check the grounding
between the stand and the printer.
48. (Optional) Assemble and install the input and output tables
for rigid cut-sheet media.
If purchased, assemble and install the roller tables as
described in the documentation that accompanies them
(DisplayMaker 72SR Table Assembly Instructions, part number
0706246). The tables are designed to be easily attached to
and removed from the printer as needed for cut-sheet or roll
fed media.
Once assembled, position the tables as shown in the instruc-
tions. Use the supplied shock cords to secure the tables to
the printer.
To ensure smooth media advance, level the tables with the
platen, using a bubble level. Hold the level on top of and
perpendicular to the platen, over each table. Adjust the
table’s leveling feet until the top of the table is level with the
platen.
One of the roller bars on each table is not permanently
attached to the table frame. You can reposition this bar as
needed to support the far side of any width of media. Simply
slide the white plastic clips under the frame support to
secure the bar.
